
Chapter 1 CLI Basics 49
Reference for the Business Policy Switch 2000 Command Line Interface
default mac-address-table aging-time command
The default mac-address-table aging-time command sets the time that
the switch retains unseen MAC addresses to 300 seconds. The syntax for the
default mac-address-table aging-time command is:
default mac-address aging-time
The default mac-address-table aging-time command is in the config
command mode.
The
default mac-address-table aging-time command has no parameters
or variables.
Displaying and setting stack operational mode
This section shows you how to view and set the stack operational mode. The
following topics are covered:
• “show stack-oper-mode command,” next
• “stack oper-mode command” on page 50
Refer to Using the Business Policy Switch 2000 Software Version 1.2 for more
information on the stack operation, including features requiring specific
operational modes and adding switches to the stack.
Table 7 mac-address-table aging-time command parameters and variables
Parameters
and
variables
Description
time
Enter the aging time in seconds that you want for MAC
addresses before they are flushed.
Comentarios a estos manuales