
66 Chapter 2 General CLI commands
212160-A
Figure 14 show telnet-access command output
telnet-access command
The telnet-access command allows you to configure the Telnet connection
used to manage the switch. The syntax for the
telnet-access command is:
telnet-access [enable|disable] [login-timeout <1-10>] [retry
<1-100>] [inactive-timeout <0-60>] [logging
{none|access|failures|all}] [source-ip <1-10>
<XXX.XXX.XXX.XXX>[mask <XXX.XXX.XXX.XXX>]]
The telnet-access command is in the config command mode.
BPS2000#show telnet-access
TELNET Access: Enabled
Login Timeout: 1 minute(s)
Login Retries: 3
Inactivity Timeout: 15 minute(s)
Event Logging: All
Allowed Source IP Address Allowed Source Mask
------------------------- -------------------
0.0.0.0 0.0.0.0
255.255.255.255 255.255.255.255
255.255.255.255 255.255.255.255
255.255.255.255 255.255.255.255
255.255.255.255 255.255.255.255
255.255.255.255 255.255.255.255
255.255.255.255 255.255.255.255
255.255.255.255 255.255.255.255
255.255.255.255 255.255.255.255
255.255.255.255 255.255.255.255
BPS2000#
Comentarios a estos manuales