Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manual de usuario descargar pdf (Pagina 179)

Chapter 6 Policy-enabled networks and QoS 179

Reference for the Business Policy Switch 2000 Command Line Interface

qos l2-filter-set command

The qos l2-filter-set command adds and deletes Layer 2 filters into an L2

filter set. The syntax for the

qos l2-filter-set command is:

qos l2-filter-set <fgid> {create set <setid> [name

<setname>] filter <fid> filter-prec <prec>|delete}

The qos l2-filter-set command is in the config command mode.

Table 104 describes the parameters and variables for the

qos l2-filter-set

command.

Table 104 qos l2-filter-set command parameters and variables

Parameters

and variables

Description

<fgid> Enter an integer to specify the filter group ID you want to work with;

range is 1 to 65535.

create set

<setid>

Initiates creation of an L2 filter set with the designated filter set ID.

Enter the IP filter set ID; range is 1 to 65535.

name

Assigns a name to the designated filter set ID. Enter the name for the

filter set; maximum is 16 alphanumeric characters.

filter <fid> Adds an L2 filter to the filter set; range is 1 to 65535.

filter-prec

<prec>

Specifies the precedence, or filter evaluation order, within the set.

Enter the precedence value you want for this filter; range is 1 to

65535.

delete Deletes the L2 filter set.

Note: You must define the filter before adding it to a filter set. You

cannot delete an L2 filter set that is referenced in an installed policy. You

cannot delete the last L2 filter in an L2 filter set that is referenced in an

installed policy.

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 199 200

Sin comentarios

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manual de usuario Pagina 179