Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manual de usuario descargar pdf (Pagina 177)

Chapter 6 Policy-enabled networks and QoS 177

Reference for the Business Policy Switch 2000 Command Line Interface

qos l2-filter command

The qos l2-filter command adds and deletes Layer 2 (L2) filters. The syntax

for the

qos l2-filter command is:

qos l2-filter <fid> {create [ethertype <etype>] [vlan <vid>]

[vlan-tag <vtag>] [priority <ieee1p-seq>] [ds-field <dscp>]

[protocol <protocoltype>] [src-port-min <port> src-port-max

<port>] [dst-port-min <port> dst-port-max <port>]|delete}

The qos l2-filter command is in the config mode.

Table 103 describes the parameters and variables for the

qos l2-filter

command.

Note: You must define the filter before adding it to a filter set.

You cannot delete an IP filter set that is referenced in an installed policy.

You cannot delete the last IP filter in an IP filter set that is referenced in

an installed policy.

Table 103 qos l2-filter command parameters and variables

Parameters and variables Description

<fid> Enter an integer to specify the filter ID; range is 1 to

65535.

create Defines a new L2 filter with the specified filter ID.

ethertype <etype> Enter the Ethernet type in the form of 0xXXXX, for

example, 0x0801.

Default is ignore.

vlan <vid> Enter the number of the VLAN ID.

Default is ignore

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 199 200

Sin comentarios

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manual de usuario Pagina 177