
50 Chapter 1 CLI Basics
212160-A
show stack-oper-mode command
The show stack-oper-mode command displays the current operational mode
of the stack and the mode set for the next switch reboot. The display shows either:
• Pure BPS 2000 Stack
or
• Hybrid Stack
The syntax for the
show stack-oper-mode command is:
show stack-oper-mode
The show stack-oper-mode command is in the privExec command mode.
The
show stack-oper-mode command has no parameters or variables.
Figure 8 displays sample output from the
show stack-oper-mode command.
Figure 8 show stack-oper-mode command output
stack oper-mode command
The stack oper-mode command allows you to set the stack operational mode,
which becomes active at the next reboot of the switch or stack. The syntax for the
stack oper-mode command is:
stack oper-mode {bps2000|hybrid}
The stack oper-mode command is in the config command mode.
Table 8 describes the parameters and variables for the
stack oper-mode
command.
BPS2000#show stack-oper-mode
Current Operational Mode: Pure BPS 2000 Stack
Next Boot Operational Mode: Pure BPS 2000 Stack
Comentarios a estos manuales