Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manual de usuario Pagina 80

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 200
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 79
80 Chapter 2 General CLI commands
212160-A
snmp trap link-status command
The snmp trap link-status command enables the linkUp/linkDown traps
for the port. The syntax of the command is:
snmp trap link-status [port <portnum|all>]
The snmp trap link-status command is in the config-if command mode.
Table 28 describes the parameters and variables for the
snmp trap
link-status
command.
no snmp trap link-status command
The no snmp trap link-status command disables the linkUp/linkDown
traps for the port. The syntax of the command is:
no snmp trap link-status [port <portnum|all>]
The no snmp trap link-status command is in the config-if command mode.
Table 29 describes the parameters and variables for the
no snmp trap
link-status
command.
Table 28 snmp trap link-status command parameters and variables
Parameters and
variables
Description
port <portnum|all> Specifies the port number to enable the linkUp/linkDown traps on.
Enter the port number or all.
Note: If you omit this parameter, the system uses the port number
you specified in the interface command.
Vista de pagina 79
1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 199 200

Comentarios a estos manuales

Sin comentarios