Avaya BayStack Operating System Switching Software (BoSS 3.1) for BayStack 460, 470 aviso descargar pdf (Pagina 77)

Release Notes for BayStack Operating System Switching Software (BoSS) 3.1

If you are replacing the base unit, remember that the stack will have a temporary

base unit. When you replace the unit, the newly replaced unit will not

automatically resume as the base unit. You must configure the replaced unit as the

base unit, using either the rear-panel Unit Select switch or the front-panel UI

button. You may reset the stack to reactivate the new base unit.

Command Line Interface (CLI) commands for unit

replacement

Use the following CLI commands for unit replacement:

To download the configuration to a replacement unit (in standalone mode):

copy tftp config unit <unit #>

To prepare the stack to receive the replacement unit (in stack mode):

stack replace unit <1-8>

RADIUS fallback enhancement

The system can use the local password of the switch or stack if the RADIUS

server is unavailable to authenticate the user for administrative access. This

option is disabled by default.

RADIUS password fallback allows you to configure password fallback as an

option when using RADIUS authentication for login and password.

Note: To insert a new unit into a stack, cable the units appropriately and

the new unit will join the stack; you do not need to reset the stack.

Note: The console and web-based management interfaces also support

unit replacement.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 85 86

Sin comentarios

Avaya BayStack Operating System Switching Software (BoSS 3.1) for BayStack 460, 470 aviso Pagina 77