Avaya BayStack Operating System Switching Software (BoSS 3.1) for BayStack 460, 470 aviso descargar pdf (Pagina 63)

Release Notes for BayStack Operating System Switching Software (BoSS) 3.1

Table 34 describes the parameters and variables for the no sntp server

command.

sntp sync-now command

The sntp sync-now command forces a manual synchronization with the NTP

server.

The syntax for the sntp sync-now command is:

sntp sync-now

The sntp sync-now command is in the config command mode.

The no sntp sync-now command has no parameters or variables.

sntp sync-interval command

The sntp sync-interval command specifies recurring synchronization with

the NTP server in hours relative to initial synchronization. The syntax for the

sntp sync-interval command is:

sntp sync-interval <0-168>

The sntp sync-interval command is in the config command mode.

Table 34 no sntp server command parameters and variables

Parameters and

variables

Description

<primary|secondary> Enter the NTP server you want to clear:

• primary—clears the IP address for the primary NTP

server

• secondary—clears the IP address for the secondary NTP

server

Note: You must have SNTP enabled before this command can take

effect.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 85 86

Sin comentarios

Avaya BayStack Operating System Switching Software (BoSS 3.1) for BayStack 460, 470 aviso Pagina 63