Avaya BayStack Operating System Switching Software (BoSS 3.1) for BayStack 460, 470 aviso descargar pdf (Pagina 36)

215148-D

consumed for the out-of-profile action. Subsequent restricted Layer-2 metered

policies will only use one filter for the in-profile-action and they will share the

out-of-profile action defined by the first filter. Since only one filter is used for

each policy, statistics will only count in-profile traffic.

Restricted meters can only be used when the Interface Class Restriction is set to

Unrestricted Only.

Configuration

To configure the BoSS Software Version 3.1 device to use restricted meters, the

following steps must be performed:

1 Ensure that the current Interface Class Restriction is set to Unrestricted Only

by entering the following CLI command.

BPS2000(config)# show qos agent

2 If the current Interface Class Restriction is not set to Unrestricted Only, you

may enable the Unrestricted Only mode by entering the following command:

BPS2000(config)# qosagent class-restrictions

unrestricted-only

3 Reboot the switch for this mode to take effect

BPS2000(config)#boot

Reboot the unit(s) (y/n) ? y

4 Assign a default action or use the default "Drop_Traffic"

BPS2000(config)# qosagent default-out-of-profile-action

name no-flow

5 Create the restricted meter

qos meter 1 create name myMeter committed-rate 5000

max-burst-rate 6000 restricted

Restricted meters are created when the "restricted" command argument is

appended to the "qos meter <meter_id> create" command.

6 Apply the new restricted meter to a policy as you would an unrestricted meter.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 85 86

Sin comentarios

Avaya BayStack Operating System Switching Software (BoSS 3.1) for BayStack 460, 470 aviso Pagina 36