Avaya BayStack Operating System Switching Software (BoSS 3.1) for BayStack 460, 470 aviso descargar pdf (Pagina 53)

Release Notes for BayStack Operating System Switching Software (BoSS) 3.1

Enabling and disabling autosave

You can enable or disable the autosave feature of your unit. Autosave

automatically saves your configuration information across reboots.

When autosave is disabled, the logging messages sent to non-volatile memory are

not saved.

You must use CLI to enable or disable autosave; the default value is enabled. This

setting is saved across resetting the unit.

Configuring with NNCLI

You use CLI to enable or disable autosave. This section discusses the following

topics:

• “show autosave command,” next

• “autosave enable command” on page 54

• “no autosave enable command” on page 54

• “default autosave enable command” on page 54

show autosave command

The show autosave command displays the status of the autosave feature, either

enabled or disabled. The syntax for the

show autosave command is:

show autosave

The show autosave command is in the privExec command mode.

The show autosave command has no parameters or variables.

Figure 7 displays sample output from the show autosave command.

Note: You can use the CLI command copy config nvram to force

a manual save of the configuration when autosave is disabled.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 85 86

Sin comentarios

Avaya BayStack Operating System Switching Software (BoSS 3.1) for BayStack 460, 470 aviso Pagina 53