Avaya IP Telephony Guía de configuración Pagina 80

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 146
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 79
80 Chapter 5 Configuring VoIP trunks
P0937663 03.1
7 The installer sets up the VoIP schedule with these settings:
Service: Manual
Overflow: Y
8 The installer ensures a route has been created to the line pool that accesses the local PSTN
line, including the external # dialout.
9 The installer defines a new route called Route 003, and sets it to use line pool PRI-A. This is
the line pool that contains the PRI fallback lines.
10 The installer defines a new route called Route 100, and sets it to use line pool O. This is the
line pool that contains the VoIP lines.
11 The installer creates a destination code of 3.
Under the Normal schedule, the installer assigns Route 003, which uses line pool PRI-A.
The absorb digits is set to All.
Under the VoIP schedule the installer assigns Route 100, which uses the VoIP lines in line
pool O. The absorb digits is set to 0.
12 The installer creates a destination code of 9, which will be used to access the local line pool for
the local PSTN access lines.
Under the Normal schedule, the installer assigns the route created for the local PSTN
access with absorb digits set to All.
Under the VoIP schedule the installer assigns the route created for the local PSTN access
with absorb digits set to All.
13 From the control set (2221), the installer dials ≤°‡‹ and selects the VoIP schedule.
VoIP is now activated. At this point, the system is configured to make outgoing calls, but it is
not set up to receive incoming calls.
14 If there are no target lines set up, the installer creates target lines for each DN or Hunt Group.
The Ottawa Business Communications Manager is now set to handle calls sent to and from a
remote VoIP gateway. However, the Santa Clara Business Communications Manager must be set
up before any calls can be made from that system.
On Business Communications Manager Santa Clara
This procedure details actions that the installer performs to set up the Business Communications
Manager Santa Clara.
1 The installer sets up 3321 as the Control set for each VoIP line, so that the VoIP route can be
manually activated.
2 The installer sets the published IP address.
In this case the public data network (PDN) is connected to the LAN 2 connection, therefore,
the installer sets the published IP address to LAN 2. This is the address that devices on the
PDN will use to locate the system.
Vista de pagina 79
1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 145 146

Comentarios a estos manuales

Sin comentarios