Avaya IP Telephony Guía de configuración descargar pdf (Pagina 36)

36 Chapter 3 Installing IP telephones

P0937663 03.1

When the telephone registers, it downloads the information from the Business Communications

Manager IP Telephony record to the telephone configuration record.

Once registration has completed, you do not need to go through the registration steps described

above unless you deregister the terminal. For information about setting the registration settings,

see “Preparing your system for IP telephone registration” on page 32.

Configuring telephone settings

If you are not automatically registered to the Business Communications Manager, you can

configure your telephone settings to allow you to access a system on the network. You will also

need to perform these steps if your IP telephone is not connected to the same LAN that the

Business Communications Manager is connected to.

Follow these steps to access the local configuration menu on an i2002 or an i2004 telephone:

1 Restart the telephone by disconnecting the power, then reconnecting the power.

After about four seconds, the top light flashes and

NORTEL NETWORKS

appears on the screen.

2 Immediately, when the greeting appears, quickly press the four display keys, one at a time,

from left to right. These keys are located directly under the display.

These keys must be pressed one after the other within 1.5 seconds or the telephone will not go

into configuration mode.

• If

Manual Cfg DHCP(0 no, 1 yes)

appears on the screen, you successfully accessed the

configuration mode.

• If any other message appears, disconnect, then reconnect the power, and try to access the

configuration mode again.

3 Enter the network parameters, as prompted.

As each parameter prompt appears, use the keypad to define values.

Use the • key to enter the period in the IP addresses.

Press

to move forward.

Note: If the telephone displays a prompt that indicates it cannot find the server,

follow the instructions in “Configuring telephone settings” to enter the specific

network path.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 145 146

Sin comentarios

Avaya IP Telephony Guía de configuración Pagina 36