
64 Chapter 5 Configuring VoIP trunks
P0937663 03.1
To put your lines into a line pool:
1 In Unified Manager, click on the keys beside Services, Telephony Services, Lines, VoIP
lines, Enabled VoIP lines
2 Click on Line XXX, where XXX is the line number for the VoIP trunk you want to put in the
line pool.
3 Click on Trunk/Line Data.
The Trunk/Line Data screen appears. Refer to Figure 18.
Figure 18 Trunk/Line data
4 In the Line type field, set a line pool that is not used by any non-VoIP lines.
5 Repeat this procedure for as many trunk lines as you have keycodes for. You can use the same
line pool for all VoIP lines.
6 On the navigation tree, click the keys beside General Settings, Access Codes, and Line Pool
Codes.
Note: Set up an access code for the line pool only if you are NOT planning to use PSTN
fallback. If you intend to use PSTN fallback, you must assign the line pool you create in
this procedure to a route, and then you need to specify a destination code. Refer to
“Configuring PSTN fallback” on page 68.
Comentarios a estos manuales