Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual de usuario descargar pdf (Pagina 96)

Configuring SNMP, BOOTP, DHCP, and RARP Services

4-4

You access all RARP parameters from the Conﬁguration Manager window (refer

to Figure 1-3). See Conﬁguring Routers or Conﬁguring Customer Access and

Trunks (BNX Software), depending on the type of installed software, for

instructions on accessing this window.

For each RARP parameter, this chapter provides information about default

settings, valid parameter options, the parameter function, instructions for setting

the parameter, and the MIB object ID.

The Technician Interface allows you to modify parameters by issuing

set and

commit commands with the MIB object ID. This process is equivalent to

modifying parameters using Site Manager. For more information about using the

Technician Interface to access the MIB, refer to Using Technician Interface

Software.

Disabling and Re-Enabling RARP Interfaces

To disable or re-enable individual RARP interfaces, begin at the Conﬁguration

Manager window (refer to Figure 1-3) and proceed as follows:

1. Select Protocols➔IP➔Reverse ARP➔Interface Table.

The RARP Interface Table window appears (Figure 4-2).

This window lists all RARP interfaces conﬁgured on the router.

2. Click on the RARP interface you want to select from the list of interfaces.

3. Set the Enable/Disable parameter.

Use the descriptions that follow as a guide.

4. Click on Apply to implement your change.

5. Click on Done to exit the window.

Caution: The Technician Interface does not verify that the value you enter for

a parameter is valid. Entering an invalid value can corrupt your

conﬁguration.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 107 108

Sin comentarios

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual de usuario Pagina 96