Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual de usuario descargar pdf (Pagina 49)

Configuring SNMP Services

1-31

Deleting a Manager

To delete a manager from an SNMP community, begin at the Conﬁguration

Manager window (refer to Figure 1-3) and complete the following steps:

1. Select Protocols➔IP➔SNMP➔Communities.

The SNMP Community List window appears (refer to Figure 1-5).

2. Select the community from which you want to delete the manager.

3. Select Community➔Managers.

The SNMP Manager List window for that community appears (refer to

Figure 1-8).

4. Select the manager you want to delete.

5. Select Manager➔Delete Manager.

The Delete SNMP Manager window appears.

6. Make sure the correct manager IP address appears.

7. Click on Delete.

Editing Threshold Parameters

You can conﬁgure thresholds for any integer, counter, gauge, or time-tick variable

in the MIB. Refer to the section “SNMP Implementation Notes” earlier in this

chapter for more information about using thresholds.

This section describes all individual threshold parameters, and how to conﬁgure

the threshold polling interval.

Conﬁguring the Threshold Polling Interval

To set the polling interval, begin at the Conﬁguration Manager window (refer to

Figure 1-3) and complete the following steps:

1. Select Protocols➔Global Protocols➔Thresholds➔Global.

The Edit Thresholds Global Parameters window appears (Figure 1-11).

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 107 108

Sin comentarios

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual de usuario Pagina 49