Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual de usuario descargar pdf (Pagina 77)

Configuring BOOTP Services

2-15

Parameter: Pass Through Mode

Default: BOOTP

Options: BOOTP

| DHCP | BOOTP and DHCP

Function: Speciﬁes whether the interface relays BOOTP, DHCP, or BOOTP and

DHCP requests.

Instructions: Select BOOTP to relay BOOTP requests.

Select DHCP to relay DHCP requests.

Select BOOTP and DHCP to relay both BOOTP and DHCP requests.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.8.3.2.1.1.5

Deleting an Input/Output Address Pair

To delete an input/output address pair, begin at the BOOTP Relay Agent

Forwarding Table window (refer to Figure 2-5) and proceed as follows:

1. Click on the address pair to select it.

2. Click on Delete.

The BOOTP Relay Agent Forwarding Table window no longer displays the

address pair.

3. Click on Done to exit the window.

Conﬁguring an AN to Use EZ-Install over a Frame Relay PVC

You must create a BOOTP client interface table if you intend to conﬁgure an

Access Node (AN) to use EZ-Install over a Frame Relay permanent virtual circuit

(PVC) in group access mode. You do not need to create this table if you

conﬁgured the Frame Relay PVC to operate in direct access mode.

The BOOTP client interface table allows you to pair the IP address of a remote

AN that will boot via EZ-Install with the local Data Link Connection Identiﬁer

(DLCI) of its Frame Relay group access PVC.

For information about conﬁguring an AN to use EZ-Install, refer to Installing and

Starting AN Routers. For information about DLCI and Frame Relay, refer to

Conﬁguring Frame Relay Services.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 107 108

Sin comentarios

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual de usuario Pagina 77