Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual de usuario descargar pdf (Pagina 79)

Configuring BOOTP Services

2-17

4. Click on OK.

The BOOTP Client Interface Table window now lists the client IP interface

and the DLCI number you added.

5. Click on Done to exit the window.

Parameter: IP Address

Default: None

Options: Any valid IP address

Function: Speciﬁes the IP address of the remote AN that will boot using EZ-Install

over a Frame Relay group access PVC connection to the router.

Instructions: Enter the IP address of the remote AN.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.8.1.1.1.3

Parameter: DLCI Number

Default: None

Range: 16 to 1007

Function: Speciﬁes the Frame Relay PVC identiﬁcation number whose destination

is the remote AN that will boot using EZ-Install. The Frame Relay

network uses the DLCI number to direct data ﬂow.

Instructions: Enter the DLCI number, in decimal format, for the group access PVC to

the remote AN. Use the DLCI number assigned by your Frame Relay

service provider.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.8.1.1.1.2

Specifying Servers for BOOTP Services

You must specify a forwarding route for BOOTREQUEST packets. You can do so

by deﬁning a relationship between an input interface and a BOOTP server. By

deﬁning such a relationship, you can

• Improve the efﬁciency of BOOTREQUEST packet relay

• Transmit BOOTREQUEST packets through unnumbered output interfaces

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 107 108

Sin comentarios

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual de usuario Pagina 79