Avaya Configuring ATM Half-Bridge Services Manual de usuario descargar pdf (Pagina 54)

Configuring ATM Half-Bridge Services

3-10

308611-14.00 Rev 00

Enabling and Disabling Proxy ARP on a Circuit

By default, proxy ARP is enabled on the AHB circuit when you configure it. This

tells the AHB router to respond to ARP requests from ATM-attached hosts with its

own hardware address as the target MAC address.

You must separately enable or disable proxy ARP on each AHB circuit on the

router.

To enable and disable proxy ARP on each AHB circuit, complete the following

tasks:

Configuring Traffic Filters for Source-Based Routing

The AHB router may use source-based routing to ensure that packets sent from a

CPE host travel to the correct ISP gateway first, regardless of its destination

address. The ISP gateway can be an edge router directly connected to an AHB

router via a WAN interface (frame relay, PPP) or a router located within the ISP

domain.

You configure source-based routing by creating an IP traffic filter whose action is

“forward to next hop.” You must specify the ISP gateway address (or a virtual

address within the ISP domain) as the next-hop address.

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

choose

Protocols

The Protocols menu opens.

2. Choose

. The IP menu opens.

3. Choose

AHB

. The AHB menu opens.

4. Choose

Circuit List.

The Edit ATM Half-Bridge Circuit List

window opens.

5. Set the

Enable Proxy ARP

parameter.

Click on

Help

or see the parameter

description on page A-7.

6. Click on

Apply

7. Click on

Done

. You return to the Configuration Manager

window.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 93 94

Comentarios a estos manuales

Sin comentarios

Avaya Configuring ATM Half-Bridge Services Manual de usuario Pagina 54

Comentarios a estos manuales

Relacionado con productos y manuales para Manuales de software Avaya Configuring ATM Half-Bridge Services