Avaya Configuring ATM Half-Bridge Services Manual de usuario descargar pdf (Pagina 36)

Configuring ATM Half-Bridge Services

2-6

308611-14.00 Rev 00

Creating an ATM Interface

To create an ATM interface, complete the following tasks:

Go to the next section to add an LLC/SNAP service record to the ATM interface

that you just created.

Adding an LLC/SNAP PVC Service Record

When you add a service record to an ATM interface, you must specify the data

encapsulation type and virtual connection it uses. AHB requires that you add the

LLC/SNAP data encapsulation type and the circuit (PVC) connection type for this

service record.

For an explanation of the different data encapsulation types and rules for assigning

data encapsulation, refer to Configuring ATM Services.

Site Manager Procedure

You do this System responds

1. In the Module List, choose an

ARE ILI link

module

(for example, ARE OC-3 MM).

2. Click on an

ATM link module connector

(labeled ATM1).

The Add Circuit window opens.

3. Supply a circuit name (or accept the

default circuit name) and click on

The Initial ATM Signaling Config window

opens.

4. Change the

Enable ATM Signaling

parameter to

Disable

Click on

Help

or see the parameter

description on page A-19.

You disable ATM signaling because AHB

runs only on PVCs, not SVCs.

Site Manager changes the value of this

parameter.

5. Click on

. The Edit ATM Connector window opens.

Caution:

You cannot edit the Data Encapsulation Type or Virtual Connection

Type parameter once you assign it to a service record. However, you can edit

the Data Encapsulation Type for individual PVCs.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 93 94

Comentarios a estos manuales

Sin comentarios

Avaya Configuring ATM Half-Bridge Services Manual de usuario Pagina 36

Comentarios a estos manuales

Relacionado con productos y manuales para Manuales de software Avaya Configuring ATM Half-Bridge Services