Avaya Configuring Ethernet, FDDI, and Token Ring Services Manual de usuario descargar pdf (Pagina 107)

BCC show Commands

305259-A Rev 00

B-7

Internal MAC Errors Number of excessive deferrals. An excessive deferral indicates that

during the previous transmission the deferral time was greater than

2.46 ms and the transmission was aborted.

Deadlock Errors Number of times the hardware entered a transmitter lockup

condition and the software attempted to work around the condition.

Excessive Collisions Number of times the transmitter failed in 16 attempts to successfully

transmit a message due to repeated collisions on the interface.

Late Collisions Number of collisions that occurred after the timeslot of the channel

elapsed.

System Errors

Slot/Conn Slot location of the Ethernet module within the chassis and the

connector number.

Memory Errors Number of internal memory errors. If this error persists, replace the

Ethernet interface hardware.

Collision Errors Number of times the driver detects that the external transceiver has

not performed the SQE test after frame transmissions. When the

SQE test is enabled on the transceiver, the transceiver asserts

collision to the Ethernet interface after every transmission to provide

an ongoing confidence test of the collision detection circuitry. An

increase in this statistic may mean only that you need to enable the

SQE test on the transceiver.

Internal Errors Number of internal buffer errors. If this error persists, replace the

Ethernet interface hardware.

Loss of Carrier Number of loss of carrier errors, in which the transceiver fails to

sense the carrier signal on the interface.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 135 136

Sin comentarios

Avaya Configuring Ethernet, FDDI, and Token Ring Services Manual de usuario Pagina 107