
- NO - disables Excessive delay detection.
• DELAY_WARN [xx] — is the threshold to give warning on Excessive Delay greater than
[xx]. The default is 150 ms. Using 0 resets the threshold to default.
- xx - is an INTEGER value used as a threshold measured in 1/1000 of a second.
• DELAY_EXCE [xx] — is the threshold to report unacceptable Excessive Delay greater
than [xx]. The default is 175 ms. Using 0 resets the threshold to default.
- xx - is an INTEGER value used as a threshold measured in 1/1000 of a second.
• SESSION_RPT_EN [YES | NO] — is used to enable or disable periodic VQMon session
reports. The default is disabled.
Both session report enable and session report interval must be configured if the
IP Deskphone software has been upgraded to SIP Release 3.0. Otherwise, the
SESSION_RPT_INT default of 60 seconds is used automatically.
- YES - enables periodic VQMon session reports.
- NO - disables periodic VQMon session reports. Default is NO.
• SESSION_RPT_INT [xx] — is used to specify the interval for the periodic VQMon session
report in seconds. The minimum acceptable value is 60 seconds. The maximum
acceptable value is 600 seconds. The default is 60 seconds.
- xx - is an INTEGER value in seconds.
System commands
• ADMIN_P
ASSWORD [password] — is used to change the default administrator password
of the IP Deskphone that is used for unlocking network menus. The default is 26567*738.
- — password - the administrator password.
IP Deskphone recovery command
• RECOVER
Y_LEVEL — controls the IP Deskphone recovery if the IP Deskphone hits any
Major or Critical error. Following values are used for setting the recovery level on the IP
Deskphone:
- 0 - IP Deskphone never recovers from any error
- 1 - IP Deskphone recovers from Major error
- 2 - IP Deskphone recovers from Major and Critical errors
Configure the provisioning server
70 SIP Software for Avaya 1200 Series IP Deskphones-Administration November 2012
Comentarios a estos manuales