Avaya SIP Software 4.0 for 1200 Series Manual de usuario descargar pdf (Pagina 69)

• LISTENING_R_WARN [xx] — is the threshold to send a report on Listening R less than

[xx]. The default value is 70. Using 0 resets it to default based on far end VOCODER.

- xx - is an INTEGER value used as threshold.

• LISTENING_R_EXCE [xx] — is the threshold to send a report on Listening R less than

[xx]. The default value is 60. Using 0 resets it to default based on far end VOCODER.

- xx - is an INTEGER value used as threshold.

• PACKET_LOSS_ENABLE [YES | NO] — is used to enable or disable the alerts based

on the packet loss thresholds. Packet loss is the fraction of RTP data packets from the

source lost since the beginning of reception. The value is an integer scaled by 256. The

range is 1 to 25600.

- YES- enables the sending of alert report based on the packet loss

- NO - disables the sending of alert report based on the packet loss

• PACKET_LOSS_WARN [xx] — is the threshold to send a report on Packet Loss greater

than [xx]. The default is 256 (1%). Using 0 resets the threshold to default.

- xx - is an INTEGER value scaled by 256 that is used as threshold. The range is 1 to

25600.

• PACKET_LOSS_EXCE [xx] — is the threshold to send a report on Packet Loss greater

than [xx]. The default is 1280 (5%). Using 0 resets the threshold to default.

- xx - is an INTEGER value scaled by 256 that is used as threshold. The range is 1 to

25600.

• JITTER_ENABLE [YES | NO] — is used to enable or disable alerts based on the inter-

arrival Jitter on incoming RTP packets inter-arrival time. The value is represented in

1/65536 of a second.

- YES - enables the sending of alert report based on jitter detection

- NO - disables the sending of alert report based on jitter detection

• JITTER_WARN [xx] — is the threshold to send a report on Inter-arrival Jitter greater than

[xx]. 1 second is broken up into 65535 (0xffff hex) parts. [xx] / 65535 is the threshold in

seconds. The default is 3276 (50 ms). Using 0 resets the threshold to default.

- xx - is an INTEGER value used as threshold

• JITTER_EXCE [xx] — is the threshold to send a report on Inter-arrival Jitter greater than

[xx]. 1 second is broken up into 65535 (0xffff hex) parts. [xx] / 65535 is the threshold in

seconds. The default is 32760 (500 ms). Using 0 resets the threshold to default.

- xx - is an INTEGER value used as threshold

• DELAY_ENABLE [YES | NO] — is used to enable or disable the alerts based on the

excessive delay detection. This is the one-way delay (including system delay) for the call,

measured in milliseconds.

- YES - enables Excessive delay detection.

VQMon configuration commands

SIP Software for Avaya 1200 Series IP Deskphones-Administration November 2012 69

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 323 324

Sin comentarios

Avaya SIP Software 4.0 for 1200 Series Manual de usuario Pagina 69