Avaya Connecting ASN Routers to a Network Manual de usuario Pagina 93

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 108
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 92
Troubleshooting Network Boot Problems
308652-14.00 Rev 00
A-11
(
config
is the name of the configuration file.) Otherwise, the change is lost when
you boot the ASN.
Debugging the BOOTP Server
Debug the BOOTP server as follows:
1.
Enter the following command at the UNIX command line:
bootpd -s -d -d&
The bootpd debugger tool reads the /etc/bootptab file and generates the
/etc/bootpd.dmp file. The /etc/bootpd.dmp file contains the portion of the
/etc/bootptab file that the bootpd debugger could read successfully. The
debugger displays messages such as the following:
[1] 12914
hostname:/etc> reading "/etc/bootptab"
read 19 entries from "/etc/bootptab"
dumped 19 entries to "/etc/bootpd.dump".
2.
Compare the
bootptab
file to the
bootpd.dmp
file.
If the bootpd.dmp file is truncated or is otherwise different from the bootptab
file, BOOTPD may have encountered a syntax error. Find the inconsistency in
the two files.
3.
Compare the inconsistency in the
bootptab
file to the sample
bootptab
file
in Figure 2-1 and correct the error.
4.
If you cannot find an inconsistency, boot the ASN and view the
bootpd
debugger messages to determine the cause of the error.
The sample messages in Table A-1
show the sequence of messages when a
BOOTP exchange is successful.
Note:
If you have not set up the network to Netboot the configuration file, an
ASN’s attempt to get the file over the network will continue for approximately
4 minutes; then the ASN will local boot the file. However, if your primary
interest is Local Boot for routine startups, you can avoid this long wait by
specifying
bconfig config local
after the Technician Interface screen
activates.
Vista de pagina 92
1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 107 108

Comentarios a estos manuales

Sin comentarios