Avaya Connecting ASN Routers to a Network Manual de usuario descargar pdf (Pagina 36)

Connecting ASN Routers to a Network

1-18

308652-14.00 Rev 00

The person at the ASN site establishes a Technician Interface session (or

you establish a session via modem).

(See the manual Installing and Maintaining ASN Routers and BNX

Platforms.)

The person at the ASN console uses the

bconfig

and

ifconfig

commands

to configure a synchronous or Ethernet interface.

(See Chapter 4 and the manual Installing and Maintaining ASN Routers and

BNX Platforms.)

You install the

netboot.exe

file in the BOOTP server’s file system, and

make sure the image and application files reside in the same directory.

(See Chapter 2.)

The person at the router site boots the router.

(See the manual Installing and Maintaining ASN Routers and BNX

Platforms.)

After the router boots, it gets a configuration file from a BOOTP server and

loads the software image from the local file system.

If the configuration file meets your network requirements, the router starts

bridging and routing traffic.

You can use the Site Manager Statistics Manager and Events Manager tools to

verify that the router is routing traffic according to the configuration you want.

(See the manual Configuring and Managing Routers with Site Manager.)

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 107 108

Sin comentarios

Avaya Connecting ASN Routers to a Network Manual de usuario Pagina 36