Avaya Configuring and Troubleshooting Bay Dial VPN (DVS) Networks Manual de usuario Pagina 83

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 188
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 82
Configuring TMS and Security for erpcd Networks
302272-A Rev. 00 5-7
hwtype
=
hw_type
hwaddr
=
hw_addr
hwalen
=
hw_addr_len
hwtype
indicates the type of network
connection between the gateway and
the CPE router. For Dial VPN,
hwtype
must be fr (frame relay) or ppp. If not
specified for a Layer 3 tunnel, the
gateway is the CPE router.
hwaddr
is a link address associated
with the network. If
hwalen
is 4 bytes or
less, you can specify it as a decimal
number. TMS converts it to a
hexadecimal number. To specify this
value as a hexadecimal number, prefix
the number with 0x. For a frame relay
connection, this argument is required; it
specifies the DLCI. For a PPP
connection, set this value to 0.
hwalen
is an optional parameter that
specifies the length in octets of the
address. If you omit this parameter, TMS
calculates its value based on the value
of the
hwaddr
parameter. For example,
if
hwaddr
is less than 256,
hwalen
will
be 1 byte. If
hwaddr
is 400,
hwalen
is 2
bytes. Unless the actual
hwaddr
length
requires it, you should accept the default
length, 1 byte. For a PPP connection,
set this value to 0.
All parts of this argument
are required for
add
and
modify
for a frame relay
connection. Not used for
other commands.
srvloc
=
servers_location
Specifies whether the authentication,
accounting, and dynamic allocation
servers are
local
(that is, on the Dial
VPN service provider’s network) or
remote
(that is, on the remote user’s
home network). The default is
local
when the
authp
(authentication
protocol) parameter is set to
acp
and
remote
when the
authp
parameter is
set to
radius
.
Required for
add
and
modify
. Not used for other
commands.
(continued)
Table 5-2. tms_dbm Command Arguments
(continued)
Argument Function
Used with These
Commands
Vista de pagina 82
1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 187 188

Comentarios a estos manuales

Sin comentarios