
Configuring and Troubleshooting Bay Dial VPN Services
5-6 302272-A Rev. 00
te
=
te_addr
Specifies the IP address of the frame
relay port on the gateway on which the
tunnel end point (te) resides. The
address 0.0.0.0 is not valid. This is the
tunnel end point nearest the remote
user’s home network.
For DVS (Layer 3) tunnels, this is the
home agent, which tunnels packets for
delivery to the remote node and
maintains current location information
for the remote node.
For Layer 2 tunnels, this is the IP
address of the LNS (interface) on the
home network.
Required for
add
and
modify
. Not used for other
commands.
ha
=
ha_addr
Not used in Dial VPN. Supported only
for compatibility with previous versions.
Specifies the IP address of the frame
relay port on the gateway in which the
home agent (ha) resides. The address
0.0.0.0 is not valid.
For compatibility with
previous versions, Dial
VPN recognizes this
parameter as equivalent to
tunnel end point (te), but it
is no longer a valid
syntactical element.
maxu
={
max_users
|
unlimited
} Specifies the maximum number of
concurrent users allowed on the system.
A value of unlimited means that any
number of concurrent users is allowed.
A value of 0 indicates that no users are
allowed on the system.
For the
modify
command, you can use
this value to disable a domain without
deleting it. If you reset the
maxu
parameter to a value below the current
number of users, additional (new) users
must wait until the count drops below
the new maximum. Excess users,
however, are not arbitrarily dropped.
Required for
add
and
modify
. Not used for other
commands.
(continued)
Table 5-2. tms_dbm Command Arguments
(continued)
Argument Function
Used with These
Commands
Comentarios a estos manuales