Avaya Configuring and Troubleshooting Bay Dial VPN (DVS) Networks Manual de usuario Pagina 73

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 188
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 72
Configuring the Remote Access Concentrator
302272-A Rev. 00 4-5
called_no
<called number>
call_action v.120
set mode auto_detect
end_session
#
begin_session sync
bearer data
called_no
<called number>
call_action sync
set mode ppp
#
# The following line applies the subnet mask to the remote device’s IP
# address.
set subnet_mask 255.255.255.0
end_session
After making these changes to the config.annex file, enter reset annex
session
from the admin prompt of the RAC. To verify that the RAC has
recognized these changes, issue the
session command at the annex prompt.
5.
Enable Syslogging.
This is not required, but it is very useful in troubleshooting. B, “Syslog
Messages” contains information on syslogs.
From the
na or admin prompt, enter the following commands:
set annex syslog_mask debug
set annex syslog_host
<ip address of syslogging host>
To enable logging in an erpcd-based system, enable erpcd syslogging and
create the appropriate log files on the host, then restart the syslog daemon. See
Managing Remote Access Concentrators Using Command Line Interfaces for
information on these functions. Refer to your UNIX system documentation
for how to perform these tasks for applications running under UNIX. The
erpcd utility uses the auth facility.
6.
Ensure that the RAC can communicate with the gateway so that a tunnel
can be established.
The RAC can learn a route to the gateway by means of RIP (Version 1 or 2) or
by means of a static route. For a static route, define the static route at the
bottom of the config.annex file. The syntax is:
route add <
destination_network
><
mask
><
next_hop
><
metric
>
Vista de pagina 72
1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 187 188

Comentarios a estos manuales

Sin comentarios