
Site Manager Parameters
117374-B Rev. 00
A-35
ATM Signaling Parameters
ATM signaling parameters define the connection and timer limits the router uses
to set up, maintain, and clear a switched connection.
The ATM Signaling Parameters window also provides access to the signaling VC
parameters. The signaling VC provides a dedicated VPI (0) and VCI (5) for ATM
signaling functions.
For control VC parameter descriptions, see “Signaling and ILMI Control VC
Parameters” on A-49
.
Parameter: Enable
Path: Configuration Manager > Protocols > ATM > ATM Signaling
Default: Enable
Options: Enable
|
Disable
Function: Enables or disables ATM signaling on this interface.
When you disable signaling on the interface, the ATM Service Record
Parameters window automatically sets the Data Encapsulation Type parameter
to LLC/SNAP and the Virtual Connection Type parameter to PVC.
Instructions: Accept the default, Enable, if you want signaling to remain enabled on this
interface. Set to Disable if you do not want signaling enabled on this interface.
MIB Object ID: 1.3.6.1.4.1.18.3.4.23.1.7.1.2
Parameter: Protocol Standard
Path: Configuration Manager > Protocols > ATM > ATM Signaling
Default: UNI_V30
Options: UNI_V30
|
UNI_V31
Function: Specifies how the interface defines Service Specific Connection Oriented
Protocol (SSCOP) frames. Version 3.0 and Version 3.1 SSCOP frames are
incompatible.
Instructions: You must assign the same protocol standard for both the router interface and the
switch. Accept the default, UNI_V30, if the switch uses UNI Version 3.0 to
define SSCOP frames. Select UNI_V31 if the switch uses UNI Version 3.1 to
define SSCOP frames.
MIB Object ID: 1.3.6.1.4.1.18.3.4.23.1.7.1.15
Comentarios a estos manuales