Avaya IP Telephony Guía de configuración descargar pdf (Pagina 82)

82 Chapter 5 Configuring VoIP trunks

P0993474 03

Setting up the VoIP schedule

You can determine which telephones/lines will choose the VoIP route as the prime route by setting

up the VoIP schedule to allow you to manually activate the service from a control set. The PSTN

route gets assigned to the Normal schedule, which runs on all telephones when no other schedule

is activated.

Rename Schedule 4 (Services, Telephony Services, Scheduled Services, Common Settings,

Schedule Names) to VoIP. Refer to the Programming Operations Guide for detailed instructions,

if required. Then follow these steps to set up the VoIP schedule for routing services:

1 Open Services, Telephony Services, Scheduled Services, Routing Service, and click on

VoIP. The VoIP schedule screen appears in the right frame.

Figure 22 VoIP Routing Service

2 Change the Service setting to Manual.

3 Change the Overflow setting to Y.

Configuring routes

Configuring routes allows you to set up access to the VoIP and the PSTN line pools. These routes

can be assigned to destination codes using schedules.

Ensure the PSTN and VoIP line pools have been configured before you continue with this section.

For information about creating a VoIP line pool, see “Putting VoIP lines into a line pool” on page

76. You can create a PSTN line pool in the same manner, if such a pool does not already exist.

Note: If you have not already done so, remember to define a route for the local PSTN for

your own system so users can still dial local PSTN numbers.

Note: If you already have routes for your PSTN or VoIP line pools configured, you do not

need to configure new routes, unless you cannot match the dialed digits. For instance, you

probably already have a PSTN route that uses 9 to access local PSTN numbers.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 179 180

Sin comentarios

Avaya IP Telephony Guía de configuración Pagina 82