
Chapter 5 Configuring VoIP trunks 79
IP Telephony Configuration Guide
Figure 20 Remote gateway dialog
3 Use the information in the table below to set up the remote gateway information.
Table 17 Remote gateway record
Field Value Description
Name <alphanumeric> Enter an indentifying tag for the remote system
Destination IP <ip address> Enter the IP address of the remote system gateway.
QoS Monitor Disabled
Enabled
Choose Enabled, if you intend to use a fallback PSTN line. Ensure
that QoS Monitor is also enabled on the remote system.
Otherwise, choose Disabled.
For information about enabling QoS, see “Turning on QoS monitor”
on page 87
Transmit Threshold read-only
Receive Threshold read-only
Gateway Type BCM3.0
BCM2.5
BCM2.0
ITG
CSE 1000
CS 3000
IMS
Choose the type of system that is accessed through the remote
gateway:
BCM3.0: Business Communications Managers running 3.0 software
*BCM2.5: Business Communications Managers running 2.5 or 2.5
FP1 or FP1 Maintenance Release software
BCM 2.0: Business Communications Managers running 2.0 software,
or Enterprise Edge systems running 2.0.x software.
ITG: M1 Internet Telephony Gateway
CSE 1000:
CS3000/IMS: CS3000 is the previous version of IMS
*If your gateway is set to BCMX.X and the other system is upgraded
to 3.0, your system will automatically update this listing to BCM3.0
when the other system is contacted after the upgrade. If this does not
occur, your original configuration may not be correct and you will
have to set the change manually.
Comentarios a estos manuales