
116 Chapter 6 Typical network applications using MCDN
P0993474 03
Figure 37 M1 to Business Communications Manager network diagram
To set up this system:
1 Make sure the M1 ITG meets the following requirements:
• ITG 2.X.26
• Rls25.30 or higher
• S/W Packages 57, 58, 59, 145, 147, 148, 160
2 Ensure that the M1 ESN programming (CDP/UDP) is compatible. For information on this,
refer to your M1 documentation.
3 On the Business Communications Manager 3.0 Unified Manager:
• Set up outgoing call configuration for the VoIP gateway.
• Set up a remote gateway for the Meridian 1.
• Ensure the dialing rules (CDP or UDP) are compatible with the M1. For information on
CDP and UDP, refer to the Programming Operations Guide.
• Configure the PSTN fallback, and enable QoS on both systems.
• If target lines have not already been set up, configure the telephones to receive incoming
calls through target lines.
MCDN functionality on fallback PRI lines
To be able to use MCDN functionality over PRI fallback lines, set up:
• Check MCDN PRI settings on the M1. For information on this, refer to the M1 documentation.
• Ensure SL-1 (MCDN) keycodes are entered on the Business Communications Manager 3.0
and the PRI line is set up for SL-1 protocol.
WarehouseHead Office
Meridian
M1
PSTN
(fallback
route)
Intranet
VoIP trunk
Business Communications Manager
System
telephone
i2004
telephone
Company
server
Telephone
Comentarios a estos manuales