Avaya IP Telephony Guía de configuración descargar pdf (Pagina 46)

46 Chapter 3 Installing IP telephones

P0993474 03

Use the * key to enter the period in the IP addresses.

Press

OK to move forward.

The following table describes the values for each display parameter.

Table 10 IP telephone server configurations

Field Value Description

DHCP 0 or 1 Enter 0 if your network is not using a DHCP server to dispense IP

addresses. (Partial DHCP)

Enter 1 if your network does use a DHCP server.

If you choose to use a DHCP server rather than allocating static IP

addresses for the IP telephones, skip the remainder of this section.

For information about setting up DHCP server information for the IP

telephones, see “Configuring DHCP” on page 49.

SET IP <ip address> The set IP must be a valid and unused IP address on the network

that the telephone is connected to.

NETMASK <subnet mask

address>

This is the subnet mask. This setting is critical for locating the system

you want to connect to.

DEF GW <ip address> Default Gateway on the network (i.e., the nearest router to the

telephone. The router for IP address W.X.Y.Z is usually at W.X.Y.1)

If there are no routers between the telephone and the Business

Communications Manager network adaptor to which it is connected,

(for example a direct HUB connection), then enter the Published IP

address of the Business Communications Manager as the DEF GW.

If the IP telephone is not connected directly to the Published IP

address network adaptor, set the DEF GW to the IP address of the

network adaptor the telephone is connected to. For information on

setting the published IP address of the Business Communications

Manager, see “Defining published IP address” on page 35.

S1 IP <ip address> This is the Published IP address of the first Business

Communications Manager that you want to register the telephone to.

S1 PORT Default: 7000 This is the port the telephone will use to access this Business

Communications Manager.

S1 ACTION Default: 1

S1 RETRY COUNT <digits between 0

and 255>

Set this to the number of times you want the telephone to retry the

connection to the Business Communications Manager.

S2 IP <ip address> This is the Published IP address of the second Business

Communications Manager that you want to register the telephone to.

It can also be the same as the S1 setting.

S2 PORT Default: 7000 This is the port the telephone will use to access this Business

Communications Manager.

S2 ACTION Default: 1

S2 RETRY COUNT <digits between 0

and 255>

Set this to the number of times you want the telephone to retry the

connection to the Business Communications Manager.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 179 180

Comentarios a estos manuales

Sin comentarios

Avaya IP Telephony Guía de configuración Pagina 46

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Avaya IP Telephony