Avaya Configuring PPP Services Manual de usuario Pagina 88

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 152
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 87
Configuring PPP Services
3-34
308639-14.00 Rev 00
Designating the Link Quality Report Timekeeper
This parameter deals with the remote peer, not the local one. The setting
determines whether the remote peer runs the link quality report (LQR) timer for
the connection. Setting this parameter enables or disables the remote peer’s LQR
timer.
The peer whose timer is enabled generates one LQR packet for each interval
specified in the LQR Reporting Period parameter. The peer whose timer is
disabled verifies that the other peer did, in fact, send an LQR. If three successive
LQRs are not received, the receiving peer disables the connection. Accept the
default, Enable, if you want the remote peer router to maintain an LQR timer for
the interface. Reset this parameter to Disable if you do not want the peer to
maintain the LQR timer for the interface.
Specifying the Link Quality Reporting Period
The LQR Reporting Period parameter specifies the maximum number of seconds
between the transmission of LQR packets. Enter a number representing the
interval between the transmission of LQR packets. The value of this parameter can
be from 1 through 120 seconds. The default value is 3 seconds.
Specifying the Inbound Link Quality
The Inbound Link Quality parameter specifies the minimum acceptable success
rate (percentage) of packets the peer router transmits and this router receives on
this interface over the last 5 LQR reporting periods. If the percentage drops below
the inbound link quality you specify, the router brings down the link until the
percentage increases to an acceptable level.
The default value for this parameter is 90 (percent). You can specify values in the
range 1 through 100 (percent).
Specifying the Outbound Link Quality
The Outbound Link Quality parameter specifies the minimum acceptable success
rate (percentage) of packets the router transmits and the peer router receives on
this interface. If the percentage drops below the outbound link quality you specify,
the router brings down the link until the percentage increases to an acceptable
level.
Vista de pagina 87
1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 151 152

Comentarios a estos manuales

Sin comentarios