Avaya Configuring PPP Services Manual de usuario descargar pdf (Pagina 72)

Configuring PPP Services

3-18

308639-14.00 Rev 00

To enable the link control protocol on this interface, do the tasks in the following

table.

To disable LCP on this interface, set Enable (LCP) parameter to Disable. To

reenable LCP, set this parameter to Enable.

Setting Transmission Parameters

You can specify the timing of transmissions and the threshold for considering the

link to be down using the parameters described in the following sections.

Setting the Restart Timer

The value of the Restart Timer in Seconds parameter specifies the number of

seconds that the restart timer waits before retransmitting data. The default value is

3 seconds, and the range is 1 through 100 seconds.

Using the BCC

Navigate to the line prompt for the circuit and enter

restart-timer

seconds

For example, the following command sets the restart timer to wait 5 seconds

before retransmitting data on circuit 3/1.

line/3/1# restart-timer 5

Site Manager Procedure

You do this System responds

1. From the Protocols menu, choose

PPP

. The Interfaces menu appears.

2. Choose

Interfaces.

The Interfaces window opens.

3. Choose

Lines

. The Lines window opens.

4. Set

Enable (LCP)

. (See page A-14.)

5. Click on

. The Interfaces window opens.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 151 152

Sin comentarios

Avaya Configuring PPP Services Manual de usuario Pagina 72