
Customizing PPP
308639-14.00 Rev 00
3-9
To enable or disable VINES support on this interface, do the tasks in the following
table.
Enabling DECnet IV Support on This Interface
If you enabled DECnet IV support when you first configured PPP on this
interface, the DECnet IV Enable parameter defaults to Enable; otherwise, the
default is Disable. To stop DECnet IV traffic from being routed over this interface,
set this parameter to Disable. This parameter enables or disables the network
control protocol for DECnet IV. It does not enable or disable DECnet IV routing
services for the interface. However, disabling the network control protocol for
DECnet IV stops DECnet IV traffic from being routed over this interface.
To enable or disable DECnet IV traffic on this interface, do the tasks in the
following table.
Site Manager Procedure
You do this System responds
1. From the Protocols menu, choose
PPP
. The Interfaces menu appears.
2. Choose
Interfaces.
The Interfaces window opens.
3. Set
VINES Enable
. (See page A-6.)
4. If you have no other Interface parameters
to configure, click on
OK
. Otherwise,
continue with the Interface configuration.
The Configuration Manager window
appears.
Site Manager Procedure
You do this System responds
1. From the Protocols menu, choose
PPP
. The Interfaces menu appears.
2. Choose
Interfaces.
The Interfaces window opens.
3. Set
DECnet IV Enable
. (See page A-4.)
4. If you have no other Interface parameters
to configure, click on
OK
. Otherwise,
continue with the Interface configuration.
The Configuration Manager window
appears.
Comentarios a estos manuales