Avaya Configuring PPP Services Manual de usuario descargar pdf (Pagina 81)

Customizing PPP

308639-14.00 Rev 00

3-27

Setting a Time Limit for Authentication

You can specify the maximum number of seconds the router waits for a response

to its authentication messages by setting the Authentication Timer parameter. If

the timer expires before the negotiation completes, the router drops the

connection. The default value is 10 seconds.

Using the BCC

The BCC does not allow you to configure this parameter.

Using Site Manager

To set a time limit for this interface, do the tasks in the following table.

Customizing PAP

When PAP is the authentication protocol, you must also specify a local PAP ID, a

local PAP password, and a remote PAP ID and remote PAP password for the peer.

During the authentication phase of link creation, PPP uses these parameters to

verify the peer’s right to communicate with the local router.

Site Manager Procedure

You do this System responds

1. From the Protocols menu, choose

PPP

. The Interfaces menu appears.

2. Choose

Interfaces.

The Interfaces window opens.

3. Choose

Lines

. The Lines window opens.

4. Set

Authentication Timer

(See page A-27.)

5. If you have no other PPP line parameters

to configure, click on

. Otherwise,

continue with the Lines configuration.

The Interfaces window opens.

Note:

For dial services that use PAP, you must configure the local PAP ID, the

local PAP password, the remote PAP ID, and the remote PAP password

through the Dial menu. See Configuring Dial Services for details.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 151 152

Sin comentarios

Avaya Configuring PPP Services Manual de usuario Pagina 81