
312 Chapter 28 Dialing plan: System settings
N0060606N0060606
To define a direct dial set
1 On the Direct Dial table, click the fields beside the set number you want to configure and enter
the appropriate values.
2 Press Tab to save the values.
3 Go to the DN records of the telephones where you want the direct dial set assigned and assign
the set under “Capabilities and Preferences - Preferences tab” in the BCM 4.0 Device
Configuration Guide (N0060600).
Configuration notes and tips
The information in this section expands on some of the fields found on the tabs on the Dialing
Plan - General panel.
• “DN length constraints” on page 312
• “Received number notes” on page 313
• “Tips about access codes” on page 314
• “Call Park codes” on page 315
DN length constraints
Facility Line
Pool (A-O)
Use prime line
Use routing table
The facility to be used to route the call to a direct dial set that you define
with an external number.
Note: If you choose Use prime line, ensure that prime line is not
assigned to the intercom buttons for your telephones. When prime line is
assigned as an intercom button, it chooses the first available line pool
assigned to the telephone to make a call. If this line pool does not have
the correct lines for routing the call, the direct dial call will fail. Refer to
“Line Access tab” in the BCM 4.0 Device Configuration
Guide (N0060600).
Note: The BCM cannot verify that the number you assign as an external direct
dial set is valid. Check the number before assigning it as a direct dial set by
calling the direct dial you have assigned.
Warning: Do not change DN length immediately after a system startup.
You must wait until the system is operational with two solid green status LEDs.
Table 68 Private and Public received numbers (Sheet 3 of 3)
Attribute Value Description
Comentarios a estos manuales