Avaya BCM 4.0 Networking Guía de configuración descargar pdf (Pagina 208)

100

101

208 Chapter 16 Configuring lines: T1-DID

N0060606N0060606

Configuring DID line features

The following procedure describes the fields that need to be confirmed or set for these lines. For

detailed field descriptions, refer to “Configuring lines” on page 165.

To configure DID line features

1 Confirm or change the settings on the Trunk/Line Data main panel:

• Trunk Type: T-1 DID

• Name: Identify the line or line function.

• Control Set: Identify a DN if you are using this line with scheduling.

• Line Type: Define as public if the line is shared, or as Private To (DN) if the line is

assigned to a specific telephone.

• Prime Set: If you want the line to be answered at another telephone if the line is not

answered at the target telephone, otherwise, choose None.

• Pub. Received #: Not applicable.

• Priv. Received #: Not applicable.

• Distinct Ring: If you want this line to have a special ring, indicate a pattern (2, 3, or 4).

• Use remote package: Not applicable.

2 Configure the trunk/line data (Properties tab):

• Dial mode: The line service will dictate whether this needs to be set to Pulse or Tone

(DTMF) dialing.

• Signaling: Match this choice with the information supplied by the service provider.

3 Set the restriction and remote package scheduling (Restrictions tab):

• Line restrictions: Enter a valid restriction filter for the Normal schedule, and any other

schedules that you want this line to be part of. (outgoing calls)

• Remote Restrictions: Enter a valid remote access package for the Normal schedule, and

any other schedules that you want this line to be part of (incoming calls from remote users

or private networks)

4 Assign the lines to DNs (Assigned DNs tab)(applicable to manual answer only)

If you have configured the DNs and know to which telephones the line needs to be assigned,

you can enter those DNs, here. The DN record also can be used to assign lines and line pools

for these lines.

• Appearance type: Choose Appear or Appear and ring if the telephone has an available

button, otherwise choose Ring Only. Model 7000 and 7100 telephones have no

programmable buttons, so this must be set to Ring only. (Model 7000 phones, supported in

Europe only.)

• VMsg set: When activated, an indicator on the telephone appears when there is a message

waiting from a remote voice mail system.

Check with your system administrator for the system voice mail setup before changing

this parameter.

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 757 758

Comentarios a estos manuales

Sin comentarios

Avaya BCM 4.0 Networking Guía de configuración Pagina 208

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Avaya BCM 4.0 Networking