Avaya BCM 4.0 Networking Guía de configuración descargar pdf (Pagina 125)

100

101

Chapter 8 Configuring telephony resources 125

BCM 4.0 Networking Configuration Guide

• DS/CLID: displays for old North American LS/DS or CLID analog trunk modules, the old analog

MBM, or the GATM with North American DIP switch settings.

• Global: displays for the GATM MBM with no regional DIP switches set.

• Legacy: displays for all other (old) analog trunk modules

Protocol NI-2, DMS100,

DMS250, AT&T4ESS,

SL-1, Euro, ETSI

Q.Sig

PRI

Choose the trunk protocol used by your service provider.

The supported protocols are:

PRI-T1: NI-2, DMS100, DMS250, AT&T4ESS, SL-1

PRI-E1: ETSI QSIG, Euro, SL-1

Note: SL-1 and ETSI QSIG require an MCDN keycode to display.

BRI: Protocol can also be selected on BRI T-loops under the Configuration > Resources >

Telephony Resources.

Note: Always check the line protocol with the central office.

NSF Extension None, WATS, ALL

PRI

The Network Specific Facilities (NSF) information element is used to request a particular service from

the network. Settings are based on the type of switch to which the line connects.

Suggested settings:

DMS100/250: NONE

Siemens ESWD, Lucent 5ESS: WATS

GTD5, DMS10: ALL

When you select NONE, the NSF extension bit is not set for any service.

When you select WATS, the NSF extension bit is set for unbanded OUTWATS calls.

When you select ALL, the NSF extension is always set for all CbC services.

Appears only for NI protocol.

Protocol type User, Network

PRI

When you select SL-1 protocol, an additional setting, Protocol type, appears.

SL-1 protocol is a private networking protocol. This allows you to designate a BCM node as a Network

(controller). The default setting is User (client). In public network configurations, the CO is generally

considered the Network side or controller.

Applies to SL-1 protocol only.

B-channel

selection

sequence

Ascending Sequential

Descending

Sequential

PRI

Defines how B-channel resources are selected for call processing.

Answer timer 1, 2, 3, 4, or 5 sec.

E&M PRI

Set the minimum duration of an answer signal before a call is considered to be answered.

Table 25 Module parameters values (Sheet 2 of 4)

Attribute Value Module/line type

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 757 758

Comentarios a estos manuales

Sin comentarios

Avaya BCM 4.0 Networking Guía de configuración Pagina 125

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Avaya BCM 4.0 Networking