Avaya BCM 4.0 Networking Guía de configuración descargar pdf (Pagina 103)

100

101

Chapter 6 Configuring resources — media bay modules 103

BCM 4.0 Networking Configuration Guide

Media bay module Bus numbers

Under the headings for DS30 2 to 7 (or 2 to 6 if your system has a 3/5 DS30 split):

• Station or analog station modules display the Ports on Module heading.

• Trunk modules display from one to four Module <#> headings. These modules correspond to

the offset configured on the module. A Ports on Module heading also appears for some types

of modules (DTM set to PRI, and the BRI modules).

• If a WAN board is installed in the base unit, DS30 08 does not appear. Bus 08 and Bus 01 are

used for internal media channels. If your system is set to a 3/5 split, DS30 07 is also used for

media channels.

Identifying the module

Use these steps to define a Programmed Type. This setting notifies the Element Manager about

what type of module is installed on the DS30 bus.

1 Click Configuration > Resources > Telephony Resources.

2 Click a Bus (2 to 7).

The details panel appears.

3 Ensure the entry in the ProgType field agrees with the Actual Type of module that is installed

for the DS30 bus, as shown Figure 24. Refer to “Module types and capacities” on page 101.

Programming tips: If the Actual Type reads None, choose the correct setting in the Prog

Type field. After the system initializes to the module, the Actual Type should change to the

correct module type. You may also have to disable, then re-enable the module to force the

system to re-initialize (click Disable or Enable under the Modules table).

Some modules take a few minutes to reinitialize.

If these actions do not cause the fields to display correctly, you may have a damaged module or

backplane. Try installing the module in a different media bay and retry the configuration.

Refer to the BCM200/400 4.0 Installation and Maintenance Guide (N0060612) for

information about removing and installing media bay modules.

4 The other headings on the Modules panel describe the current status of the modules, as

described in the Table 19.

Note: If you receive the error message Telephony programming is

currently not available. Please try again later.

when

you click one of the column headings, this means that the part of the

system that handles MSC is performing a reset. Wait 1and1/2 minutes

and try again.

Note: Bus number is determined by the DS30 number set on the DIP

switches of the module before it was installed.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 757 758

Comentarios a estos manuales

Sin comentarios

Avaya BCM 4.0 Networking Guía de configuración Pagina 103

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Avaya BCM 4.0 Networking