Avaya Business Communications Manager 5.0 - Fault and Performance Management Manual de usuario descargar pdf (Pagina 27)

Using the BCM fault management system 27

Nortel Business Communications Manager 5.0

Fault and Performance Management

NN40170-701 01.01 Standard

August 2009

3 In the Alarm Settings table, select an alarm.

4 In the Enable SNMP Trap column, select or clear the check box to enable

or disable SNMP traps for the selected alarm. If you select the check box for

a selected alarm, an SNMP trap will be generated if that particular alarm

condition occurs.

--End--

Enabling or disabling monitoring for selected alarms

Use the following procedure to enable or disable alarms.

Procedure steps

Step Action

1 Click the Administration tab.

2 Open the General folder, and then click the Alarm Settings task.

The Alarm Settings pane opens.

3 In the Alarms Settings table, select an alarm.

4 In the Enable GUI View column, select or clear the check box to enable or

disable a view of the selected alarm in the Alarms Panel. If you clear the

check box for a selected alarm, the alarm will not be displayed in the Alarms

table if that particular alarm condition occurs in the system.

--End--

Monitoring settings for the alarm set

Use the following procedure to monitor settings for the alarm set.

Procedure steps

Step Action

1 Click the Administration tab.

2 Open the General folder, and then click the Alarm Settings task.

The Alarm Settings pane opens.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 69 70

Sin comentarios

Avaya Business Communications Manager 5.0 - Fault and Performance Management Manual de usuario Pagina 27