Avaya R2MFC Guía de configuración descargar pdf (Pagina 37)

Chapter 3 Installing the R2MFC MBM 37

R2MFC Media Bay Module Installation and Configuration Guide

Removing an R2MFC MBM from the expansion unit

Use this procedure to remove an R2MFC MBM from the BCM expansion unit.

1 Power-down the BCM expansion unit system (see “Shutting down the system” on page 31).

2 Remove any cabling from the R2MFC MBM faceplate.

3 Remove the expansion unit front bezel.

4 Grasp the edge of the MBM ejector lever. Pull outward to eject the R2MFC MBM. Refer to

Figure 11.

Figure 11 How to remove the expansion unit front bezel

5 Grasp the top and bottom edges of the R2MFC MBM. Remove the R2MFC MBM from the

BCM expansion unit. Place the R2MFC MBM in a clean, safe, and static-free area.

Wiring an R2MFC MBM

This section describes how to wire the cables that connect to the R2MFC MBM. The R2MFC

MBM is connected to the CO by either RJ48C or BNC connectors. The BNC connector is the

default interface. The default connector can be changed either by setting the country - selection

DIP switches or by creating a custom country code profile through the CLI. See “Configuring the

MFCR2 (external) link” on page 45 for information on how to change the active interface.

If the 75 Ω BNC connector pair is used, two coax cables are required for transmit and receive.

If the 120 Ω RJ-48 connector is used, the cable pinout must be set up as follows:

Warning: Remove the R2MFC MBM after the system is powered down.

BCM expansion unit

1. Push against the bottom

2. Pull out from the top

MBM latches

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 105 106

Sin comentarios

Avaya R2MFC Guía de configuración Pagina 37