Avaya R2MFC Guía de configuración descargar pdf (Pagina 33)

Chapter 3 Installing the R2MFC MBM 33

R2MFC Media Bay Module Installation and Configuration Guide

switches” on page 45. For information about how to set the underside switches, refer to the

Installation and Maintenance guide for the host BCM.

2 Select an open media bay.

3 With the face of the R2MFC MBM facing toward you, insert the R2MFC MBM into the open

bay.

4 Push the R2MFC MBM completely into the unit. You will hear a click when the module is

firmly seated in the media bay.

Installing an R2MFC MBM in the expansion unit

Perform the following steps to install an R2MFC MBM in the BCM expansion unit chassis. Install

the R2MFC MBM when the system is powered down:

1 Ensure that both the faceplate and underside DIP switches on the R2MFC MBM are set

correctly. For information on how to set the faceplate switches, refer to “Setting Config DIP

switches” on page 45. For information about how to set the underside switches, refer to the

BCM Installation and Maintenance guide for the host system.

2 Remove the front bezel from the expansion unit.

3 Select an open media bay.

4 With the faceplate of the R2MFC MBM facing toward you, insert the R2MFC MBM into the

open bay. Ensure that any cables at the rear of the module are clear of the platform base

chassis.

5 Push the R2MFC MBM into the unit. You will hear a click when the module is firmly seated

in the media bay.

6 Install the front bezel on the expansion unit.

Reconnecting the equipment

After you install the module correctly into the bay, you must return the equipment to operation.

Caution: Only install the R2MFC MBM when the system is powered dow. See

“Shutting down the system” on page 31.

Warning: Failure to follow procedures to properly disconnect the BCM and

expansion unit can result in module or system damage.

Caution: Complete the following steps carefully to ensure you return your

system to operation without endangering the equipment or yourself.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 105 106

Sin comentarios

Avaya R2MFC Guía de configuración Pagina 33