Avaya Using Technician Interface Scripts Manual de usuario Pagina 774

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 849
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 773
117380-A Rev. A 3-1
Chapter 3
Using enable/disable Commands
You can enable and disable network protocols, services, and interfaces from the
Technician Interface command line, using the general syntax of the
enable/disable
commands as follows:
enable
<service>
or disable
<service>
<service>
is the name of the protocol or service you want to enable or disable.
To display a help message on an
enable or disable command, enter the command
followed by a question mark. For example, to display help for the
enable at command,
enter
enable at ?.
The sample displays in this section show how to use the
enable commands only. However,
disable commands follow the same syntax.
Vista de pagina 773
1 2 ... 769 770 771 772 773 774 775 776 777 778 779 ... 848 849

Comentarios a estos manuales

Sin comentarios