
show dcm
117380-A Rev. A 2-187
Boot Option Whether DCM boots from the boot image in its Flash memory
(LOCAL), or downloads an image in the DCM board’s shared
DRAM (DOWNLOAD).
Image Name Name of the active DCM image.
Image Save Mode Whether DCM saves the boot image in shared memory to the DCM
board Flash memory (SAVE), or leaves it in RAM to be lost at the
next boot (NO_SAVE).
Config Source Whether DCM uses the configuration information in its Flash
memory (LOCAL), or a configuration file in the DCM board’s shared
DRAM (SHARED).
Config Save Mode Whether DCM saves configuration information currently in RAM to
the DCM board Flash memory (WRITE), or leaves it in RAM to be
lost at the next boot (NO_WRITE).
Maximum # Hosts per
Entry
Maximum number of host address entries in the RMON Host
Control table. This limit changes according to the amount of
memory available to DCM. If the table reaches the maximum value,
DCM deletes entries based on an LRU (least recently used)
algorithm.
Configured # Hosts
per Entry
Current number of host address entries configured in the RMON
Host Control table.
Create Host Control
Tabl e
Whether DCM sets up the RMON Default Host table at every boot
(ENABLED), or lets an RMON application set up the table
(DISABLED). Some RMON network management applications
expect the DCM to set up a host configuration. Others enable and
disable their own configurations during normal operations. Note
that the DCM allows only one host table.
Create Matrix
Control Table
Whether DCM sets up the RMON Matrix Control table at every boot
(ENABLED), or lets an RMON application set up the table
(DISABLED). Some RMON network management applications
expect the DCM to set up a matrix configuration. Others enable and
disable their own configurations during normal operations. Note
that the DCM allows only one matrix table.
Note: With current revisions of DCM software, the RMON Host and Matrix
tables are created by default; you cannot delete or disable these tables.
Comentarios a estos manuales