
Using Technician Interface Scripts
2-298 117380-A Rev. A
congestion [
<line>
|
<line.llindex>
|
<line.llindex.DLCI>
]
Displays information about congestion control on frame relay interfaces. You can use the
following options with the
congestion command.
The table includes the following information.
<line>
Limits the display to the specified line.
<line.llindex>
Limits the display to the specified interface.
<line.llindex.DLCI>
Limits the display to the specified PVC.
<
line.llindex
>
specifies the
interface.
<
dlci
>
specifies the individual PVC.
Line.LLIndex Line or instance identifier for the interface.
Circuit Name of the main circuit this interface is associated with.
Enable Status of congestion control: Disabled, Enabled, or Inherit. Inherit
indicates that the VC should use the parameters from the DLCMI
record.
State Status of traffic; options are
• forwarding - sending traffic at up to the maximum rate allowed on
the PVC.
• congested - the PVC is not transmitting.
• throttling - the PVC is throttling back to the CIR rate.
Method Identifies the congestion method:
• Shutdown - the VC terminates when congestion occurs.
• Throttle - the VC queues traffic when congestion occurs; traffic
resumes when the congestion alleviates.
• Throttle then shutdown - first queues traffic when congestion
occurs, and then terminates the VC if throttling does not alleviate
congestion.
• Inherit -the VC uses the parameter from the DLCMI record
Timer Length of time in seconds during which the router counts
congestion notifications.
Counter Maximum number of congestion notifications that the router can
receive during the Timer period before it stops transmitting.
RX FECN Number of outbound forward explicit congestion notifications.
RX BECN Number of outbound backward explicit congestion notifications.
Comentarios a estos manuales