Avaya Configuring IP Utilities Manual de usuario Pagina 29

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 198
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 28
Starting TCP, FTP, TFTP, Telnet, NTP, and NetBIOS over IP
117358-A Rev. A 1-7
Step 1: Configuring a Physical Interface
To configure a physical interface on a slot and connector, navigate to the top-level
box prompt and enter:
interface_type
slot
slot_number
connector
connector_number
interface_type
is the name of a link module on the router.
slot_number
is the number of the slot on which the link module is located.
connector_number
is the number of a connector on the link module.
For example, the following command configures an Ethernet interface on slot 2,
connector 2.
box# ethernet slot 2 connector 2
ethernet/2/2#
Step 2: Configuring an IP Interface
To configure an IP interface on a physical interface, navigate to the prompt for the
physical interface and enter:
ip address
address
mask
mask
address
and
mask
are a valid IP address and its associated mask, expressed in
either dotted-decimal notation or in bit notation.
For example, the following command configures IP interface 2.2.2.2/255.0.0.0 on
an Ethernet physical interface on slot 2, connector 2.
ethernet/2/2# ip address 2.2.2.2 mask 255.0.0.0
ip/2.2.2.2/255.0.0.0#
An IP interface is now configured on the Ethernet interface with default values for
all interface parameters. When you configure an IP interface, the BCC also
configures IP globally on the router with default values for all IP global
parameters.
You can customize IP by modifying IP global and interface parameters as
described in Configuring IP Services.
Vista de pagina 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 197 198

Comentarios a estos manuales

Sin comentarios