Avaya IP Telephony Guía de configuración descargar pdf (Pagina 46)

46 Chapter 3 Installing IP telephones

P0604630 03

After registration is complete, you do not need to go through the registration steps described above

unless you deregister the terminal. For information about setting the registration settings, see

“Preparing your system for IP telephone registration” on page 41.

Configuring telephone settings

If you are not automatically registered to the Business Communications Manager, you can

configure your telephone settings to allow you to access a system on the network. You will also

need to perform these steps if your IP telephone is not connected to the same LAN to which the

Business Communications Manager is connected.

Follow these steps to access the local configuration menu on an i2002 or an i2004 telephone:

1 Restart the telephone by disconnecting the power, then reconnecting the power.

After about four seconds, the top light flashes and

NORTEL NETWORKS appears on the screen.

2 When the greeting appears, immediately, and quickly, press the four display keys, one at a

time, from left to right. These keys are located directly under the display.

These keys must be pressed one after the other within 1.5 seconds or the telephone will not go

into configuration mode.

• If

Manual Cfg DHCP(0 no, 1 yes) appears on the screen, you successfully accessed the

configuration mode.

• If any other message appears, disconnect, then reconnect the power, and try to access the

configuration mode again.

3 Enter the network parameters, as prompted.

As each parameter prompt appears, use the keypad to define values.

Use the * key to enter the period in the IP addresses.

Press

OK to move forward.

The following table describes the values for each display parameter.

Note: If the telephone displays a prompt that indicates it cannot find the server, follow the

instructions in “Configuring telephone settings” to enter the specific network path.

“Troubleshooting an IP telephone” on page 48 describes other possible prompt messages.

Table 12 IP telephone server configurations

Field Value Description

DHCP 0 or 1 Enter 0 if your network is not using a DHCP server to dispense IP

addresses. (Partial DHCP)

Enter 1 if your network does use a DHCP server.

If you choose to use a DHCP server rather than allocating static IP

addresses for the IP telephones, skip the remainder of this section.

For information about setting up DHCP server information for the IP

telephones, see “Configuring DHCP” on page 50.

SET IP <ip address> The set IP must be a valid and unused IP address on the network that

the telephone is connected to.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 211 212

Comentarios a estos manuales

Sin comentarios

Avaya IP Telephony Guía de configuración Pagina 46

Comentarios a estos manuales

Relacionado con productos y manuales para Manuales de software Avaya IP Telephony