Avaya IP Telephony Guía de configuración descargar pdf (Pagina 102)

102 Chapter 6 Setting up VoIP trunks for outgoing calls

P0604630 03

To set up the line configurations, use the line record for each enabled line. All lines that are

assigned to the same line pool should have the same programming.

1 Click on the keys beside Services, Telephony Services, Lines, VoIP lines, Enabled VoIP

lines.

2 Click on the General heading to enter:

• a new name for the line

• a control set for the line

3 Click on the Trunk/line data heading and set the parameters you require for your system. The

line must belong to a line pool that contains the same type of VoIP line.

4 If you want specific restrictions assigned to the lines, fill out the information under the

Restrictions heading.

5 Repeat these steps for all the lines that are active. Ensure that you put the H.323 trunks and SIP

trunks in separate line pools.

Note: Configuring SIP and H.323 trunks in the same line pool may result in unpredictable

results since they do not support the same level of service. SIP trunks, for example, do not

support MCDN-protocol services, T.38 fax protocol, or NetVision-generated calls.

Configuring telephones to access the VoIP lines

For each telephone that will be allowed to use the VoIP line pools, you must add the VoIP line

pool to the DN record for that telephone:

1 In Unified Manager, open Services, Telephony Services, System DNs, Active Set DNs,

DN XXX, Line Access.

DN XXX is any DN that you want to allow to use VoIP trunking.

2 Click Line Pool Access.

3 Click Add.

The Add Line Pool Access dialog box appears.

4 Type the letter of the VoIP line pool.

5 Click the Save button.

6 Repeat steps 4 and 5 if you have both H.323 and SIP line pools and you want to assign both to

the telephone.

7 Repeat this procedure for every telephone you want to allow to use VoIP line pools.

8 If you plan to use fallback for your VoIP lines, you need to configure the VoIP line pools into

routes and assign a destination code for the route. Refer to the Programming Operations

Guide for details about creating routes and destination codes.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 211 212

Sin comentarios

Avaya IP Telephony Guía de configuración Pagina 102