Avaya IP Telephony Guía de configuración Pagina 36

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 212
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 35
36 Chapter 2 Prerequisites checklist
P0604630 03
VoIP trunks
Complete this section if you are configuring VoIP trunks.
T.38 UDP Redundancy 0, 1, 2, 3 If T.38 fax is enabled on the system, this setting defines how many
times the message is resent during a transmission in order to avoid
errors caused by lost T.38 messages.
Default: 0
Reserved Media
Gateway Codec
G.711
G.729
G.723
Choose the preferred codec that you are using with your IP network.
Reserved Media Gateway Codec should be set to whatever is the
most-commonly used codec for Media Gateways. It determines the
amount of codec resources reserved for each Media Gateway.
Reserving resources speeds up establishment of connections. For
example, if most calls through a Media Gateway use the G.711
codec, set this to G.711. If most calls use G.729, set this to G.729.
Note that the higher the setting (G.723 > G.729 > G.711) the more
resources are set aside for Media Gateways. This may result in calls
failing to go through because of lack of available resources.
For a more detailed descriptions of the media gateway or other information about the media services card (MSC)
settings for the Business Communications System, refer to the Programming Operations Guide, MSC section.
Table 9 VoIP trunk provisioning
Prerequisites Yes No
7.a Have you confirmed the remote gateway settings and access codes required? (H.323 and
SIP trunks).
7.b Have you determined the preferred codecs required for each type of trunk and destination?
7.c Have you determined how you are going to split your VoIP resources between H.323 and
SIP trunks.
7.d Have you set up line parameters, determined line pools for H.323 and/or SIP trunks, and
set up routing and destination codes? Have you determined which system telephones will
have access to these routes?
7.e If you have not already assigned target lines, have you defined how you are going to
distribute them on your system?
Table 8 IP terminals general record fields (Continued)
Field Value Description
Vista de pagina 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 211 212

Comentarios a estos manuales

Sin comentarios